ASTM-D6576 › Standard Specification for Flexible Cellular Rubber Chemically Blown
The following bibliographic material is provided to assist you with your purchasing decision:
This specification establishes requirements for chemically blown cellular rubber. Cellular rubber may be classified into two types: Type I which is open cell or sponge rubber and Type II which is closed cell or expanded rubber. Both types are divided into three grades: Grade A which is oil-and flame-resistant, Grade B which has no requirements for oil ,flame resistance, or low temperature, and Grade C which is low-temperature resistant. Each type and class has been divided into three different conditions. Each condition is based on a specific range of firmness as expressed by compression deflection as follows: super soft, soft, soft-medium, medium, medium-firm, and firm conditions. Several tests shall be performed in order to determine the following physical properties of cellular rubber: compression deflection, low-temperature resistance, accelerated aging, recovery, flame resistance, shrinkage, water absorption, oil aging, and color.
Scope
1.1 This specification establishes requirements for chemically blown cellular rubber.
1.2 In the case of conflict between the provisions of this specification and those of detailed specifications or test methods for a particular product, the latter shall take precedence.
1.3 Unless specifically stated otherwise, by agreement between the purchaser and the supplier, all test methods shall be performed in accordance with the test methods specified in this specification.
1.4 The values stated in SI units are to be regarded as the standard. The inch-pound units given in parentheses are for information only.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.6 There is no known ISO equivalent to this specification.
Note 1: This specification was revised using the updated test methods and specifications in the latest version of Specification D1056.
1.7 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Keywords
cellular; closed-cell; elastomeric; flexible; open cell; rubber;
To find similar documents by ASTM Volume:
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Customers who bought this document also bought:
AMS-INDEXSAE AMS Index, Aerospace Material Specifications
ASTM-D2000
Standard Classification System for Rubber Products in Automotive Applications
ASTM-D2240
Standard Test Method for Rubber Property—Durometer Hardness
Document Number
ASTM-D6576-20
Revision Level
2020 EDITION
Status
Current
Modification Type
Revision
Publication Date
July 24, 2020
Document Type
Specification
Page Count
8 pages
Committee Number
D20.22