Document Center is acquired by Nimonik

Scope

1.1 This test method covers measuring alkalinity in low-alkalinity (less than 0.002 meq/g basicity) polyols. This alkalinity is often expressed as CPR (controlled polymerization rate) of polyether polyols. This test method is not applicable to amine-based polyols.

1.2 The values stated in SI units are to be regarded as the standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Note 1-There is no similar or equivalent ISO standard.

Keywords

alkalinity; basicity; CPR; polyether polyol; polyol; polyurethane; prepolymer; raw materials; test method; titration; urethane; ICS Number Code 83.040.01 (Raw materials for rubber and plastics in general)

To find similar documents by ASTM Volume:

08.03 (Plastics (III): D5117 - latest; Reinforced Plastic Piping Systems and Chemical Equipment; Plastic Building Products)

To find similar documents by classification:

83.040.01 (Raw materials for rubber and plastics in general)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.