ASTM-D623 › Standard Test Methods for Rubber Property—Heat Generation and Flexing Fatigue In Compression
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 These test methods may be used to compare the fatigue characteristics and rate of heat generation of different rubber vulcanizates when they are subjected to dynamic compressive strains.
1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.
1.3 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
rubber test; flexing; heat; compression; fatigue; ICS Number Code 83.060 (Rubber)
To find similar documents by ASTM Volume:
09.01 (Rubber, Natural and Synthetic -- General Test Methods; Carbon Black)
To find similar documents by classification:
83.060 (Rubber Raw rubber, see 83.040.10)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Customers who bought this document also bought:
ASTM-A240Standard Specification for Chromium and Chromium-Nickel Stainless Steel Plate, Sheet, and Strip for Pressure Vessels and for General Applications
ASTM-A480
Standard Specification for General Requirements for Flat-Rolled Stainless and Heat-Resisting Steel Plate, Sheet, and Strip
ASTM-A1008
Standard Specification for Steel, Sheet, Cold-Rolled, Carbon, Structural, High-Strength Low-Alloy, High-Strength Low-Alloy with Improved Formability, Solution Hardened, and Bake Hardenable
Document Number
ASTM-D0623-07R19E01
Revision Level
2007 R19(E1) EDITION
Status
Current
Modification Type
Revision
Publication Date
March 19, 2021
Document Type
Test Method
Page Count
7 pages
Committee Number
D11.15