ASTM-D6003 Historical Revision Information
Determining Weight Loss From Plastic Materials Exposed To Simulated Municipal Solid-Waste

ASTM-D6003 - 1996 EDITION - CANCELLED
Show Complete Document History

Document Center Inc. is an authorized dealer of ASTM standards.
The following bibliographic material is provided to assist you with your purchasing decision:

Standard Test Method for Determining Weight Loss From Plastic Materials Exposed to Simulated Municipal Solid-Waste (MSW) Aerobic Compost Environment (Withdrawn 2005)
ORDER

Scope

1.1 This test method is used to determine the degree and rate of aerobic biodegradation of plastic materials exposed to a controlled composting environment. Aerobic composting takes place in an environment where temperature, aeration, and humidity are closely monitored and controlled.

1.2 The test is designed to determine the biodegradability of plastic materials, relative to that of a standard material, in an aerobic environment. Aeration of the test reactors is maintained at a constant rate throughout the test and reactor vessels of a size no greater than 4-L volume are used to ensure that the temperature of the vessels is approximately the same as that of the controlled environment chamber.

1.3 Biodegradability of the plastic is assessed by determining the amount of weight loss from samples exposed to a biologically active compost relative to the weight loss from samples exposed to a "poisoned" control.

1.4 The test is designed to be applicable to all plastic materials that are not inhibitory to the bacteria and fungi present in the simulated Municipal Solid Waste (MSW).

1.5 The values stated in SI units are to be regarded as the standard.

1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Note 1- There is no similar or equivalent ISO standard.

Keywords

abiotic; aerobic; biodegradation; compost; ICS Number Code 13.030.10 (Solid wastes); 83.040.01 (Raw materials for rubber and plastics in general)

To find similar documents by ASTM Volume:

08.03 (Plastics (III): D5117 - latest; Reinforced Plastic Piping Systems and Chemical Equipment; Plastic Building Products)

To find similar documents by classification:

13.030.10 (Solid wastes)

83.040.01 (Raw materials for rubber and plastics in general)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.

Document Number

ASTM-D6003-96

Revision Level

1996 EDITION

Status

Cancelled

Modification Type

Withdrawn

Publication Date

Aug. 10, 1996

Document Type

Test Method

Page Count

8 pages

Committee Number

D20.96