ASTM-D5917 › Standard Test Method for Trace Impurities in Monocyclic Aromatic Hydrocarbons by Gas Chromatography and External Calibration
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method covers the determination of the total nonaromatic hydrocarbons and trace monocyclic aromatic hydrocarbons in toluene and mixed xylenes by gas chromatography. The purity of toluene or mixed xylenes can also be calculated. Calibration of the gas chromatographic system is done by the external standard calibration technique. A similar test method, using the internal standard calibration technique, is Test Method D2360.
1.2 Total aliphatic hydrocarbons containing 1 through 10 carbon atoms (methane through decanes) can be detected by this test method at concentrations ranging from 0.001 to 2.500 weight %.
1.2.1 A small amount of benzene in mixed xylenes may not be distinguished from the nonaromatics and the concentrations are determined as a composite (see 6.1).
1.3 Monocyclic aromatic hydrocarbon impurities containing 6 through 9 carbon atoms (benzene through C 9 aromatics) can be detected by this test method at individual concentrations ranging from 0.001 to 1.000 weight %.
1.4 The following applies to all specified limits in this test method: for purposes of determining conformance with this test method, an observed value or a calculated value shall be rounded off "to the nearest unit" in the last right-hand digit used in expressing the specification limit, in accordance with the rounding-off method of Practice E29.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific hazard statement, see Section 9.
Keywords
aromatics; external standard; gas chromatography; impurities; purity; toluene; xylenes; ICS Number Code 71.040.50 (Physicochemical methods of analysis); 71.080.15 (Aromatic hydrocarbons)
To find similar documents by ASTM Volume:
06.04 (Paint -- Solvents; Aromatic Hydrocarbons)
To find similar documents by classification:
71.080.15 (Aromatic hydrocarbons)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D5917-15E01
Revision Level
2015 R19 EDITION
Status
Superseded
Modification Type
Revision
Publication Date
June 1, 2019
Document Type
Test Method
Page Count
8 pages
Committee Number
D16.01