Document Center is acquired by Nimonik

Scope

1.1 This test method covers construction and operation of a circular orifice weir for measuring the discharge from a well. This test method is a part of a series of standards prepared on the in situ determination of hydraulic properties of aquifer systems by single- or multiple-well tests. Selection of a well discharge measurement test method is described in Guide D5737.

1.2 This test method is common to a number of aquifer test methods and to evaluation of well and pump performance.

1.3 Limitations--This test method is limited to the description of a method common to hydraulic engineering for the purpose of ground water discharge measurement in temporary or test conditions.

1.4 Much of the information presented in this test method is based on work performed by the Civil Engineering Department of Purdue University during the late 1940s. The essentials of that work have been presented in a pamphlet prepared by Layne-Bowler, Inc. and updated by Layne Western Company, Inc.

1.5 The values stated in inch-pound units are to be regarded as the standard. The SI units given in parentheses are for information only.

1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Keywords

aquifers; aquifer test methods; discharge rate; ground water; orifice weir; ICS Number Code 93.025 (External water conveyance systems)

To find similar documents by ASTM Volume:

04.08 (Soil and Rock (I): D420 - D5876)

To find similar documents by classification:

93.025 (External water conveyance systems Including buried and above ground installations Internal water supply systems, see 91.140.60)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.