ASTM-D5225 › Standard Test Method for Measuring Solution Viscosity of Polymers with a Differential Viscometer
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method covers the determination of the solution viscosity of polymers using a differential or the modified differential viscometer. It is applicable to all polymers that dissolve completely without chemical reaction or degradation to form solutions that are stable with time and temperature. Results of the test are usually expressed as specific viscosity, intrinsic viscosity (limiting viscosity number), inherent viscosity (logarithmic viscosity number), or relative viscosity (viscosity ratio).
1.2 Since there is more than one type of viscometer available to measure a differential pressure, follow the manufacturer’s directions applicable to the equipment being used.
1.3 The solution viscosity values are comparable with those obtained using a glass capillary of Test Method D2857. This test method differs from the glass capillary in that the solvent and the solution are compared at the same time that a test is run. With a glass capillary, each solution must be referenced back to the solvent run in the same capillary at the same temperature.
1.4 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. For specific hazard statements, see Section 8.
Note 1: There is no known ISO equivalent to this standard.
1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Significance and Use
5.1 Solution viscosity values for polymers are related to the average molecular size of that portion of the polymer which dissolves in the solvent.
Keywords
differential solution viscosity; differential viscometer; polymer solution viscosity;
To find similar documents by ASTM Volume:
To find similar documents by classification:
83.080.01 (Plastics in general)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Customers who bought this document also bought:
IPC/JEDEC-J-STD-020Moisture/Reflow Sensitivity Classification for Nonhermetic Surface Mount Devices
ISO/IEC-17025
General requirements for the competence of testing and calibration laboratories
AIAG-TS-GS
ISO/TS-16949 2002 Iatf Guidance Supplement
Document Number
ASTM-D5225-22
Revision Level
2022 EDITION
Status
Current
Modification Type
Revision
Publication Date
Sept. 12, 2022
Document Type
Test Method
Page Count
5 pages
Committee Number
D20.70