Document Center is acquired by Nimonik

Scope

1.1 This test method covers the determination of the total vapor pressure of air-containing, volatile, petroleum products. This test method is suitable for testing samples with boiling points above 0°C (32°F) that exert a vapor pressure between 7 and 172 kPa (1 and 25 psi) at 37.8°C (100°F) at a vapor-to-liquid ratio of 4:1. This test method is suitable for testing gasoline samples that contain oxygenates. No account is made of dissolved water in the sample.

1.1.1 Some gasoline-oxygenate blends may show a haze when cooled to 0 to 1°C. If a haze is observed in 8.5, it shall be indicated in the reporting of results. The precision and bias statements for hazy samples have not been determined (see Note 8).

1.2 This test method is suitable for the calculation of a dry vapor pressure equivalent (DVPE) by means of a correlation equation (see 13.1). The calculated DVPE very closely approximates the dry vapor pressure that would be obtained on the same material when tested in accordance with Test Method D 4953.

1.3 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific hazard statements, see 7.3 through 7.5 and 9.2.

Significance and Use

Vapor pressure is an important physical property of volatile liquids.

The vapor pressure of gasoline and gasoline-oxygenate blends is regulated by various government agencies.

Specifications for volatile petroleum products generally include vapor pressure limits to ensure products of suitable volatility performance.

This test method is more precise than Test Method D 4953.

Keywords

automated vapor pressure measurement; dry vapor pressure; gasoline; hydrocarbon-oxygenate blends; petroleum products; vapor pressure; Automated procedures petroleum products analysis; Calibration petroleum analysis instrumentation; Dry vapor pressure; Gasoline; Gasoline-oxygenate blends; Hydrocarbon-oxygenate blends; Petroleum products; Petroleum samples; Pressure testing petroleum products; Vapor pressure (VPx) petroleum products; ICS Number Code 75.080 (Petroleum products in general)

To find similar documents by ASTM Volume:

05.02 (Petroleum Products and Lubricants (II): D3711 - D6122)

05.03 (Petroleum Products and Lubricants (III): D6138 - D6971)

To find similar documents by classification:

75.080 (Petroleum products in general)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.