ASTM-D5054 › Standard Test Method for Rubber Chemicals—Diphenyl Guanidine (DPG) and Di-o-tolyl-guanidine (DOTG) Assay (Withdrawn 2018)
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method covers the determination of assay of diphenyl guanidine (DPG) and di-o-tolyl-guanidine (DOTG). It is based on a visual titration of DPG or DOTG with hydrochloric acid (HCl).
1.2 The assay is determined as mass percent.
1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Significance and Use
4.1 DPG and DOTG are used for rubber and latex vulcanization acceleration. The amount of DPG or DOTG may be of importance in predicting performance in rubber compounds and for raw material purchase and control.
4.2 This test method may be used as a quality control tool and for research and development work.
Keywords
di-o-tolyl-guanidine (DOTG); diphenyl guanidine (DPG);
To find similar documents by ASTM Volume:
09.01 (Rubber, Natural and Synthetic -- General Test Methods; Carbon Black)
To find similar documents by classification:
83.060 (Rubber Raw rubber, see 83.040.10)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D5054-90(2014)
Revision Level
1990 R14 EDITION
Status
Cancelled
Modification Type
Withdrawn
Publication Date
Nov. 15, 2014
Document Type
Test Method
Page Count
3 pages
Committee Number
D11.11