Document Center is acquired by Nimonik

Scope

1.1 This test method describes a procedure for the determination of the coefficient of static friction of paper measured when sliding against itself. The inclined plane procedure is used.

1.2 Although this test method is basic in concept, the precision statement has been developed on uncoated writing and printing papers. While the use of this test method is recommended for those grades only, it may be used with other types of paper giving specific attention to special paper characteristics and with the understanding that the precision may not be the same.

1.3 Static coefficient of friction (COF) relates to the force required to initiate movement between two surfaces while kinetic COF relates to the force required to cause continuation of the movement at uniform speed. Kinetic COF cannot be measured by this test method. Both static and kinetic COF can be measured by Test Method D 4917.

1.4 A horizontal plane method is described in Test Method D 4917, which gives similar results. The choice of approach depends upon the equipment available and the means of measurement.

1.5 The determination of this characteristic for corrugated and solid fiberboard is described in Test Methods D 4521 and D 3247. The test methods differ in that, in Test Methods D 4521 and D 3247, the two specimens are allowed to slip upon one another three times before the angle of inclination is determined, while in this test method, the angle is determined on the first slip.

1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Significance and Use

The coefficient of friction of printing and writing papers indicates the ease with which the top or bottom sheet of a stack of paper will slide across the succeeding sheet, such as occurs on the infeed of a sheet-fed printing press or the sheet transport into a copier machine. A minimum coefficient of friction is required to prevent the double-feeding of any sheets.

Since each sheet is removed from the stack only once, a single slide of each pair of specimens is performed and the value recorded.

FIG. 1 Schematic of Inclined Plane Apparatus

Keywords

COF; friction; force; kinetic; corrugated; ICS Number Code 85.080 (Paper products); 85.080.10 (Office paper)

To find similar documents by ASTM Volume:

15.09 (Paper; Business Imaging Products)

To find similar documents by classification:

85.080 (Paper products Including paper based stationery Other forms of stationery (non-paper based), see 35.260 and 97.180)

85.080.10 (Office paper)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.