Document Center is acquired by Nimonik

Scope

1.1 Test Method A—Describes a chemical (titrametric) procedure for the determination of acrylic acid dimer in acrylic acid. This procedure may be applicable to other unsaturated organic acids.

1.2 Test Method B—Describes a gas chromatographic procedure for the determination of acrylic acid dimer in acrylic acid. Other impurities may also be determined simultaneously.

1.3 The following applies to all specified limits in this standard; for purposes of determining conformance with this standard, an observed value or a calculated value shall be rounded off "to the nearest unit" in the last right-hand digit used in expressing the specification limit, in accordance with the rounding-off method of Practice E 29.

1.4 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific hazard statements, see Section 8.

Significance and Use

These test methods provide a measurement of the dimer content of acrylic acid. The results of this measurement can be used for specification purposes but must be on an as-shipped basis since the dimer content will vary with the age and the storage temperature of the acrylic acid.

Keywords

acrylic acid; dimer; gas chromatograph; titrametric; ICS Number Code 71.080.40 (Organic acids)

To find similar documents by ASTM Volume:

06.04 (Paint -- Solvents; Aromatic Hydrocarbons)

To find similar documents by classification:

71.080.40 (Organic acids)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.