Document Center is acquired by Nimonik

Scope

1.1 This test method is intended for use in the evaluation of the chemical resistance of fiberglass-reinforced thermosetting resins that are subjected to one-side panel exposure to specific environments. It takes into consideration the coldwall effects and radiation losses of heat transfer through the laminate wall.

1.2 This test method is supplemental to Practice C 581 and does not supersede it. Note 1 - There is no known ISO equivalent to this standard.

This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Significance and Use

The results obtained by this test method may serve as a guide in, but not as the sole basis for, predicting the possible performance of the particular glass-fiber-reinforced thermosetting resin laminate in the one-side exposure to the specific environment under evaluation. No attempt has been made to incorporate into the test method all of the factors that may enter into the serviceability of a glass-fiber-reinforced resin structure when subjected to chemical environments.

This test method provides for the determination of changes in the physical properties of the test panel and test media during and after the one-side exposure in the test media. Determination of changes include: Barcol hardness, appearance of panel, appearance of test media, flexural properties, and thickness.

Keywords

contact molded; corrosion resistant equipment; glass-fiber reinforced; laminate; reinforced thermosetting plastic (RTP); thermoset epoxy resin; thermoset polyester resin; thermoset vinyl ester resin; ICS Number Code 83.120 (Reinforced plastics)

To find similar documents by ASTM Volume:

08.03 (Plastics (III): D5117 - latest; Reinforced Plastic Piping Systems and Chemical Equipment; Plastic Building Products)

To find similar documents by classification:

83.120 (Reinforced plastics Materials for the reinforcement of plastics, see 59.100)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.