Document Center is acquired by Nimonik

Scope

1.1 This test method describes a test to confirm the sterility of either manufacturer presterilized or user-sterilized analytical membrane filters.

1.2 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. ^

Significance and Use

This test method may be employed to check the sterility of commercially procured sterile membrane filters. The test also confirms that sterilized filters have not been contaminated. Additionally, this test may be used to monitor the efficacy of in-house sterilization procedures. Filter packages that have obvious packaging defects should not be tested because sterility may have been compromised.

Keywords

filters; membrane; sterility; Laminar flow rooms; Membrane filters (MF)--water testing; Microorganisms; Sterilization--water analysis

To find similar documents by ASTM Volume:

11.02 (Water (II))

To find similar documents by classification:

11.080.99 (Other standards related to sterilization and disinfection)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.