ASTM-D3648 › Standard Practices for the Measurement of Radioactivity
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 These practices cover a review of the accepted counting practices currently used in radiochemical analyses. The practices are divided into four sections:
| Section |
General Information | 6 – 11 |
Alpha Counting | 12 – 22 |
Beta Counting | 23 – 33 |
Gamma Counting | 34 – 41 |
1.2 The general information sections contain information applicable to all types of radioactive measurements, while each of the other sections is specific for a particular type of radiation.
1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Significance and Use
5.1 This practice was developed for the purpose of summarizing the various generic radiometric techniques, equipment, and practices that are used for the measurement of radioactivity.
Keywords
alpha counting; beta counting; gamma-ray counting; radioactivity detection; radioactivity measurement; water ;
To find similar documents by ASTM Volume:
To find similar documents by classification:
17.240 (Radiation measurements Including dosimetry Radiation protection, see 13.280)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Customers who bought this document also bought:
NAS-410NAS Certification and Qualification of Nondestructive Test Personnel
AWS-D17.1/D17.1M
Specification for Fusion Welding for Aerospace Applications
MIL-H-7199
Heat Treatment of Wrought Copper-Beryllium Alloys, Process for (Copper Alloys: Numbers C17000, C17200, C17300, C17500, and C17510) (Superseded by SAE-AMS-H-7199)
Document Number
ASTM-D3648-23
Revision Level
2023 EDITION
Status
Current
Modification Type
Reinstated
Publication Date
July 28, 2023
Document Type
Practice
Page Count
28 pages
Committee Number
D19.04