ASTM-D3504 › Standard Specification for Maleic Anhydride (Withdrawn 2012)
The following bibliographic material is provided to assist you with your purchasing decision:
This specification covers the standard requirements for maleic anhydride. The material shall be tested and sampled in accordance with standard test methods and practices and shall conform to the following requirements: solidification point and color of the specimens in the molten state and after heating in the platinum-cobalt scale.
Scope
1.1 This specification covers maleic anhydride.
1.2 The following applies to all specified limits in this specification: for purposes of determining conformance with this specification, an observed value or a calculated value shall be rounded off "to the nearest unit" in the last right-hand digit used in expressing the specification limit, in accordance with the rounding-off method of Practice E 29.
1.3 Consult current OSHA regulations and supplier's Material Safety Data Sheets, and local regulations for all materials used in this specification.
Keywords
maleic anhydride; platinum-cobalt color; solidification point; ICS Number Code 71.080.50 (Anhydrides)
To find similar documents by ASTM Volume:
06.04 (Paint -- Solvents; Aromatic Hydrocarbons)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D3504-96(2003)e1
Revision Level
1996 R03(E1) EDITION
Status
Superseded
Modification Type
Withdrawn
Publication Date
Feb. 10, 2003
Document Type
Specification
Page Count
1 page
Committee Number
D16.02