ASTM-D3429 Standard Test Method for Solubility of Fixed Gases in Low-Boiling Liquids (Withdrawn 2017)

ASTM-D3429 - 1993 R12 EDITION - CANCELLED
Show Complete Document History

Document Center Inc. is an authorized dealer of ASTM standards.
The following bibliographic material is provided to assist you with your purchasing decision:

Standard Test Method for Solubility of Fixed Gases in Low-Boiling Liquids (Withdrawn 2017)

Scope

1.1 This test method covers the determination of the solubilities of nonreactive gases such as nitrogen and helium in liquids that boil below 273 K. This test method is applicable at temperatures from 77 to 300 K from subambient pressure to 6.5 MPa (65 atm). This test method does not provide for analysis of the vapor phase in equilibrium with the liquid (see Section 3 for a description of terms).

1.2 This test method as written describes the procedures to be followed for determination of the solubilities of helium and nitrogen. If suitable modifications are made to the analytical measurements by gas chromatography, solubilities of other gases such as argon, hydrogen, oxygen, etc., can be determined.

1.3 The values stated in SI units are to be regarded as the standard. In cases where materials, products, or equipment are available in inch-pound units only, SI units are omitted.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific hazard statements, see 6.1.2 and 7.1 and Annex A1.

Significance and Use

The solubility of fixed gases in liquids is an important engineering parameter in the design of hydraulic systems. It is a measure of the amount of gas that can be released from solution when a system undergoes changes in pressure and temperature. Theoretical considerations permit approximate values of gas solubility to be computed with reasonable accuracy. Dissolved gases are separated and quantified chromatographically. The test method is restricted to use with low-boiling liquid samples.

Keywords

fixed gases; low-boiling liquids; solubility ; Fixed gases; Gases; Gas solubility; Low-boiling liquids; Petroleum products (liquid); Solubility; ICS Number Code 75.060 (Natural gas)

To find similar documents by ASTM Volume:

05.01 (Petroleum Products and Lubricants (I): D56 - D3710)

To find similar documents by classification:

75.060 (Natural gas)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.

Document Number

ASTM-D3429-93(2012)

Revision Level

1993 R12 EDITION

Status

Cancelled

Modification Type

Withdrawn

Publication Date

May 15, 2012

Document Type

Test Method

Page Count

8 pages

Committee Number

D02.L0.07