ASTM-D2724 › Standard Test Method for Bond Strength of Bonded, Fused, and Laminated Apparel Fabrics
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method covers procedures for characterizing the bond strength of bonded, fused, and laminated apparel fabrics before or after drycleaning and laundering.
1.2 The values stated in SI units are to be regarded as standard; the values in parentheses are provided as information only.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. See 6.1.1 for a specific warning.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Significance and Use
5.1 This test method for the determination of bond strength of bonded, fused, or laminated apparel fabrics, is considered satisfactory for acceptance testing of commercial shipments of bonded and laminated apparel fabrics.
5.1.1 If there are differences of practical significance between reported test results for two laboratories (or more), comparative tests should be performed to determine if there is a statistical bias between them, using competent statistical assistance. As a minimum, use the samples for such a comparative test that are as homogeneous as possible, drawn from the same lot of material as the samples that resulted in disparate results during initial testing. Randomly assign specimens in equal numbers to each laboratory. The test results from the laboratories involved should be compared using a statistical test for unpaired data and a probability level chosen prior to the testing series. If bias is found, either its cause must be found and corrected, or future test results for that material must be adjusted in consideration of the known bias.
Keywords
apparel; bonded fabric; delamination strength;
To find similar documents by ASTM Volume:
07.01 (Textiles (I): D76 - D4391)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Customers who bought this document also bought:
ASTM-A240Standard Specification for Chromium and Chromium-Nickel Stainless Steel Plate, Sheet, and Strip for Pressure Vessels and for General Applications
ASTM-D4169
Standard Practice for Performance Testing of Shipping Containers and Systems
WIRE TRANSFER FEE
Bank Fee for Wire Transfer
Document Number
ASTM-D2724-19
Revision Level
2019 EDITION
Status
Current
Modification Type
Revision with Title Change
Publication Date
Jan. 1, 2019
Document Type
Test Method
Page Count
5 pages
Committee Number
D13.59