ASTM-D2364 › Historical Revision Information
Standard Test Methods for Hydroxyethylcellulose
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 These test methods cover the testing of hydroxyethylcellulose.
1.2 The test procedures appear in the following order:
Sections | |
Moisture | 4-9 |
Ash | 10-17 |
Viscosity | 18-24 |
Density | 25-31 |
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Significance and Use
The results of this test are used for calculating the total solids in the sample; and, by common usage, all materials volatile at this test temperature are designated as moisture.
Moisture analysis (along with sulfated ash) is a measure of the amount of active polymer in the material and must be considered when determining the amount of hydroxyethyl cellulose to use in various formulations.
Keywords
ash; density; hydroxyethylcellulose; moisture; molar substitution; viscosity; ICS Number Code 85.040 (Pulps)
To find similar documents by ASTM Volume:
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D2364-01(2007)e1
Revision Level
2001 R07(E1) EDITION
Status
Superseded
Modification Type
Reapproval with Ed Change
Publication Date
June 1, 2007
Document Type
Test Method
Page Count
5 pages
Committee Number
D01.36