Document Center is acquired by Nimonik

Scope

1.1 These test methods cover procedures for testing rigid electrical insulation normally manufactured in flat sheet or plate form. They are generally used as terminal boards, spacers, voltage barriers, and circuit boards.

Note 1—For tests applying to vulcanized fibre reference should be made to Test Methods D 619.

1.2 The test methods appear in the following sections:

1.3 The values stated in inch-pound units are to be regarded as the standard. The metric equivalents of inch-pound units given in these test methods may be approximate.

1.4 This is a fire-test-response standard. See Sections 61 through 75, which are the procedures for burning rate and flame resistance.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific precautionary statements are given in 31.1 and 61.5.

Keywords

ac breakdown voltage; arc resistance; ash content; bond strength; compressive strength; dissipation factor; elastic modulus; flame resistance; flexural strength; hard rubber; impact resistance; insulation resistance; permittivity; printed wiring boards; resistivity; rigid plates; rigid sheets; Rockwell hardness; solvent extractible; spacers; surface resistance; surface resistivity; tensile strength; terminal boards; thermal expansion; thermosetting laminate; thickness; tracking resistance; twist; voltage barriers; volume resistivity; warp; water absorption; ICS Number Code 29.035.01 (Insulating materials in general)

To find similar documents by ASTM Volume:

10.01 (Electrical Insulation (I): D69 - D2484)

To find similar documents by classification:

29.035.01 (Insulating materials in general)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.