ASTM-D2062 › Historical Revision Information
Standard Test Methods for Operability of Zippers
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 These test methods cover procedures for determining the following characteristics of zippers:
Sections | |
Opening and Closing of Zippers | 14-17 |
Separator Functioning of Zippers | 18-22 |
Sticking of Zippers at Stops | 10-13 |
1.2 The values stated in SI units are to be regarded as the standard. No other units of measurement are included in this standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Significance and Use
The significance of specific tests is discussed in the appropriate sections.
These test methods are considered satisfactory for acceptance testing of commercial shipments of zippers because the methods have been used extensively in the trade for this purpose, even though current estimates of between-laboratory precision are quite large in some cases.
If there are differences of practical significance between reported test results for two laboratories (or more), comparative test should be performed to determine if there is a statistical bias between them, using competent statistical assistance. As a minimum, the test samples should be used that are as homogeneous as possible, that are drawn from the material from which the disparate test results were obtained, and that are randomly assigned in equal numbers to each laboratory for testing. Other materials with established test values may be used for this purpose. The test results from the two laboratories should be compared using a statistical test for unpaired data, at a probability level chosen prior to the testing series. If a bias is found, either its cause must be found and corrected, or future test results must be adjusted in consideration of the known bias.
The method(s) in the standard along with those in Test Methods D 2051
FIG. 1 Slider Sticking on Bottom Stop
Keywords
operability; zipper; Closing; Opening/operating force; Operating characteristics; Separator functioning; Sticking (at stops); Zippers; ICS Number Code 61.040 (Headgear. Clothing accessories. Fastening of clothing)
To find similar documents by ASTM Volume:
07.01 (Textiles (I): D76 - D4391)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D2062-03(2009)
Revision Level
2003 R09 EDITION
Status
Superseded
Modification Type
Reapproval
Publication Date
Aug. 1, 2009
Document Type
Test Method
Page Count
6 pages
Committee Number
D13.54