ASTM-D1838 › Standard Test Method for Copper Strip Corrosion by Liquefied Petroleum (LP) Gases
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method covers the detection of the presence of components in liquefied petroleum gases which can be corrosive to copper.
Note 1: For an equivalent copper strip test applicable to less volatile petroleum products, see Test Method D130.
1.2 The values stated in SI units are to be regarded as standard.
1.2.1 Exception—The values given in parentheses are for information only.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. For specific warning statements, see 7.1, 10.3.1, and Annex A1.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Significance and Use
5.1 Copper corrosion limits provide assurance that difficulties will not be experienced in deterioration of the copper and copper-alloy fittings and connections that are commonly used in many types of utilization, storage, and transportation equipment.
Keywords
copper corrosion; copper strip; liquefied petroleum gases;
To find similar documents by ASTM Volume:
05.01 (Petroleum Products and Lubricants (I): D56 - D3710)
To find similar documents by classification:
77.060 (Corrosion of metals Surface treatment and coating, see 25.220)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Customers who bought this document also bought:
IPC-A-610Acceptability of Electronic Assemblies (Hardcopy format)
IPC-A-600
Acceptability of Printed Boards
IPC-2221
Generic Standard on Printed Board Design
Document Number
ASTM-D1838-21
Revision Level
2021 EDITION
Status
Current
Modification Type
Revision
Publication Date
July 14, 2021
Document Type
Test Method
Page Count
6 pages
Committee Number
D02.H0