Document Center is acquired by Nimonik

Scope

1.1 This specification covers composition, thickness, fabricating procedures, and physical property requirements for glass fiber reinforced thermoset polyester, vinyl ester, or other qualified thermosetting resin laminates comprising the materials of construction for RTP corrosion-resistant tanks, piping, and equipment. This specification is limited to fabrication by contact molding.

Note 1-The laminates covered by this specification are manufactured during fabrication of contact-molded RTP tanks, piping, and other equipment. Note 2-There is no similar or equivalent ISO standard.

1.2 The following safety hazards caveat pertains only to the test method portion, Section 8, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Keywords

corrosive service applications-plast; contact-molded reinforced thermosetting plastic (RTP) laminates for; corrosion resistant equipment, spec., ; Plast (reinforced thermosetting)-structural; contact-molded reinforced thermosetting plastic (RTP) laminates for; corrosion resistant equipment

To find similar documents by ASTM Volume:

08.03 (Plastics (III): D5117 - latest; Reinforced Plastic Piping Systems and Chemical Equipment; Plastic Building Products)

To find similar documents by classification:

83.140.20 (Laminated sheets)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.