ASTM-C279 › Standard Specification for Chemical-Resistant Masonry Units
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This specification covers solid, kiln fired brick and tile made from clay, shale, or mixtures thereof, suitable for indoor and outdoor use in masonry construction subjected to chemical environments.
1.2 The physical and chemical properties of brick and tile differ from supplier to supplier, mainly because their composition is determined by the source of raw materials. Regardless of the differences, brick and tile are considered to be of three types as follows:
1.2.1 Type I--For use where low absorption and high acid resistance are not major factors.
1.2.2 Type II--For use where lower absorption and higher acid resistance are required.
1.2.3 Type III--For use where minimum absorption and maximum acid resistance are required.
Note 1-Types I, II, and III may not differ significantly in thermal shock resistance. The suitability of a given brick, for a particular application should be determined at the time of purchase by agreement between the purchaser and the supplier.
Note 2--Types I and III were formerly designated Type "H'' and "L'' respectively.1.3 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
absorption; acid resistance; acid solubility; ceramic; chemical-resistant; masonry; physical properties; solid brick; ICS Number Code 91.100.15 (Mineral materials and products)
To find similar documents by ASTM Volume:
To find similar documents by classification:
91.100.15 (Mineral materials and products Including earth, sands, clay, slates, stones, etc.)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Customers who bought this document also bought:
ASTM-D1621Standard Test Method for Compressive Properties of Rigid Cellular Plastics
ASTM-C273
Standard Test Method for Shear Properties of Sandwich Core Materials
ASTM-D2842
Standard Test Method for Water Absorption of Rigid Cellular Plastics
Document Number
ASTM-C0279-23
Revision Level
2023 EDITION
Status
Current
Modification Type
Reapproval
Publication Date
July 11, 2023
Document Type
Specification
Page Count
3 pages
Committee Number
C15.02