ASTM-C195 › Standard Specification for Mineral Fiber Thermal Insulating Cement
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This specification covers mineral fiber thermal insulating materials in the form of dry cement, which, when mixed with a suitable proportion of water, applied as a plastic mass, and dried in place, affords resistance to heat transmission on surfaces operating at temperatures between 250 and 1900oF (about 121and 1038oC).
1.2 The values stated in inch-pound units are to be regarded as the standard. The SI equivalents of inch-pound units are given in parentheses and may be approximate.
1.3 The following safety hazards caveat pertains only to the test methods section of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
insulating cement; mineral fiber; thermal insulation; ICS Number Code 91.100.10 (Cement. Gypsum. Lime. Mortar)
To find similar documents by ASTM Volume:
04.06 (Thermal Insulation; Building and Environmental Acoustics)
To find similar documents by classification:
91.100.10 (Cement. Gypsum. Lime. Mortar)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Customers who bought this document also bought:
ACI-318Building Code Requirements for Structural Concrete and Commentary
NFPA-25
Standard for the Inspection, Testing, and Maintenance of Water-Based Fire Protection Systems
NFPA-96
Standard for Ventilation Control and Fire Protection of Commercial Cooking Operations
Document Number
ASTM-C0195-07R24
Revision Level
2007 R24 EDITION
Status
Current
Publication Date
Sept. 19, 2024
Document Type
Specification
Page Count
3 pages
Committee Number
C16.20