ASTM-C1660 › Standard Specification for Thin-bed Mortar for Autoclaved Aerated Concrete (AAC) Masonry
The following bibliographic material is provided to assist you with your purchasing decision:
This specification addresses the material and performance requirements of thin-bed mortar used in the construction of autoclaved aerated concrete (AAC) masonry. Materials used in the preparation of the thin-bed mortar shall conform to the requirements specified in referenced ASTM documents itemized herein. These materials include masonry cement, fine aggregates, Portland cement, hydrated lime, blended hydraulic cement, hydraulic cement, mortar cement, rapid hardening hydraulic cement, and adhesives. Properly sampled test specimens shall adhere to the minimum splitting tensile strength requirements specified for its class.
Scope
1.1 This specification applies to thin-bed mortar for autoclaved aerated concrete (AAC) masonry.
1.2 The testing laboratory performing these test methods shall be evaluated in accordance with Practice C1093.
1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
1.4 This standard may involve hazardous materials, operations, and equipment. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Keywords
autoclaved aerated concrete (AAC); masonry; splitting tensile strength; thin-bed mortar;
To find similar documents by ASTM Volume:
To find similar documents by classification:
91.100.10 (Cement. Gypsum. Lime. Mortar)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-C1660-24
Revision Level
2024 EDITION
Status
Current
Modification Type
Revision
Publication Date
Dec. 31, 2024
Document Type
Specification
Page Count
4 pages
Committee Number
C15.30