ASTM-C1336 › Standard Practice for Fabricating Non-Oxide Ceramic Reference Specimens Containing Seeded Inclusions (Withdrawn 2018)
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This practice covers a procedure for fabricating both green and sintered test samples of silicon carbide and silicon nitride containing inclusions. These samples can be used to determine the sensitivity and detection capability of a nondestructive examination (NDE) method.
1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Significance and Use
4.1 This practice describes a method of fabrication of known discontinuities in a ceramic specimen. Such specimens are needed and used in nondestructive examination to demonstrate sensitivity and resolution and to assist in establishing proper examination parameters.
Keywords
advanced ceramics; non-oxide ceramics; ICS Number Code 81.060.01 (Ceramics in general)
To find similar documents by ASTM Volume:
15.01 (Refractories, Activated Carbon; Advanced Ceramics)
To find similar documents by classification:
81.060.01 (Ceramics in general)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-C1336-96(2014)
Revision Level
1996 R14 EDITION
Status
Cancelled
Modification Type
Withdrawn
Publication Date
Jan. 15, 2014
Document Type
Practice
Page Count
3 pages
Committee Number
C28.03