Document Center is acquired by Nimonik

Scope

1.1 This specification covers magnesium alloys in sheet and plate form designated as shown in Table 1.

1.2 The values stated in either inch-pound or SI units are to be regarded separately as standards. The SI units are shown in brackets or in separate tables or columns. The values stated in each system are not exact equivalents; therefore, each system must be used independent of the other. Combining values from the two systems may result in nonconformance with the specification.

1.3 Unless the order specifies the "M" specification designation, the material shall be furnished to the inch-pound units.

Keywords

Magnesium alloys; UNS M11311 (magnesium alloy); UNS M11312 (magnesium alloy); UNS M13210 (magnesium alloy); UNS M13310 (magnesium alloy, casting); UNS M14141 (magnesium alloy); UNS M16100 (magnesium alloy); Mg-alloy-sheet/plate, spec; ICS Number Code 77.150.20 (Magnesium products)

To find similar documents by ASTM Volume:

02.02 (Aluminum and Magnesium Alloys)

To find similar documents by classification:

77.150.20 (Magnesium products)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.