ASTM-B813 › Standard Specification for Liquid and Paste Fluxes for Soldering of Copper and Copper Alloy Tube
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This specification establishes the requirements and test methods for liquid and paste fluxes for joining by soldering of copper and copper alloy tube and fittings in plumbing, heating, air conditioning, mechanical, fire sprinkler, and other similar systems.
Note 1--This specification does not apply to fluxes intended for electronic applications.
1.2 Solder fluxes are to be tested in accordance with the requirements of theis specification by an independent testing laboratory. Testing, measuring equipment, and inspection facilities shall be of sufficient accuracy and quality to comply with the requirement of this specification.
1.3 Units--The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.4 The following hazard caveat pertains to Sections 11-19.This standard does not purport to address the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
aggressiveness test; copper and copper alloys; corrosiveness; flushing; liquid and paste fluxes; resistivity; soldering; spreading factor; tarnish; viscosity
To find similar documents by ASTM Volume:
02.01 (Copper and Copper Alloys)
To find similar documents by classification:
25.160.50 (Brazing and soldering Including brazing and soldering alloys and equipment)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-B0813-24
Revision Level
2024 EDITION
Status
Current
Modification Type
Title Change
Publication Date
July 19, 2024
Document Type
Specification
Page Count
7 pages
Committee Number
B05.04