ASTM-B687 › Standard Specification for Brass, Copper, and Chromium-Plated Pipe Nipples
The following bibliographic material is provided to assist you with your purchasing decision:
This specification establishes the requirements for brass and copper pipe nipples within a specified size range. Chromium-plated pipe nipples covered by this specification are intended for use in the interior of decorative appliances. Both brass and copper pipe nipples should be produced from regular or extra strong pipes while chromium-plated pipe nipples are produced from regular weight brass pipes. All pipe nipples should be threaded in both ends with NPT Taper Pipe Threads except for close nipples with lengths shorter than the specified value. Threads should be right hand on both ends except when otherwise specified. Chromium plated nipples use short plumbing (hospital) threads. Pipe nipple ends shall be cut reasonable square to the central axis and chamfered on the outside with all outside burrs removed.
Scope
1.1 This specification establishes the requirements for brass and copper pipe nipples in standard pipe sizes from 1/8 to 8 in., inclusive, in standard lengths, and chromium-plated pipe nipples in standard pipe sizes from 1/8 to 2 in., inclusive, in standard lengths.
1.1.1 Chromium-plated pipe nipples ordered under this specification are intended for interior use in decorative applications.
1.2 The values stated in inch-pound units are the standard. The values given in parentheses are for information only.
This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
close nipple; pipe nipple; short plumbing (hospital) threads; ICS Number Code 23.040.60 (Flanges, couplings and joints)
To find similar documents by ASTM Volume:
02.01 (Copper and Copper Alloys)
To find similar documents by classification:
23.040.60 (Flanges, couplings and joints)
To find similar documents by Federal Supply Class Code:
FSC 4730 (Hose, Pipe, Tube, Lubrication, and Railing Fittings)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-B0687-99R23
Revision Level
1999 R23 EDITION
Status
Current
Modification Type
Reapproval with Ed Change
Publication Date
May 1, 2023
Document Type
Specification
Page Count
5 pages
Committee Number
B05.04