Document Center is acquired by Nimonik

Scope

1.1 This specification covers UNS N08925, UNS N08354, and UNS N08926 welded pipe for general corrosion applications.

1.2 This specification covers pipe sizes in schedules shown in Table 1.

1.3 ASTM International has adopted definitions whereby some grades, such as UNS N08904, previously in this specification were recognized as stainless steels, because those grades have iron as the largest element by mass percent. Such grades are under the oversight of ASTM Committee A01 and its subcommittees. The products of N08904 previously covered in this specification are now covered by Specification A312/A312M.

1.4 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to become familiar with all hazards including those identified in the appropriate Material Safety Data Sheet (MSDS) for this product/material as provided by the manufacturer, to establish appropriate safety and health practices, and determine the applicability of regulatory limitations prior to use.

TABLE 1 Dimensions of Welded Pipe

Note 1—The following table is a partial reprint of Table 1 of ANSI B36.19.

Note 2—The decimal thicknesses listed for the respective pipe sizes represent their nominal wall dimensions.

Note 3—1 in. = 25.4 mm.

^A Schedule 5S and 10S wall thicknesses do not permit threading in accordance with ANSI B2.1.

^B These do not conform to ANSI B31.10.

^C These do not conform to ANSI for Welded and Seamless Wrought Steel Pipe (ANSI B36.10).

Keywords

UNS N08925; UNS N08354; UNS N08926; welded pipe; Nickel alloy pipe--specifications; Nickel-chromium alloys--specifications; Nickel-chromium-molybdenum alloys--specifications; Nickel-iron-chromium-molybdenum-copper alloys--specifications; UNS N08904 (Ni-Cr-Mo alloy); UNS N08925 (Ni-Fe-Cr-Mo-Cu-low-carbon alloy); UNS N08926 (Ni-Fe-Cr-Mo-Cu-N alloy, low C, N modified); Welded Ni/Ni alloy pipe--specifications; Corrosive service applications--pipe (Ni/Ni alloy); ICS Number Code 77.150.40 (Nickel and chromium products)

To find similar documents by ASTM Volume:

02.04 (Nonferrous Metals--Nickel, Cobalt, Lead, Tin, Zinc, Cadmium, Precious, Reactive, Refractory Metals and Alloys; Materials for Thermostats, Electrical Heating and Resistance Contacts, and Connectors)

To find similar documents by classification:

77.150.40 (Nickel and chromium products)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.