Document Center is acquired by Nimonik

Scope

1.1 This test method covers the determination of indentation hardness of aluminum alloys with a Webster hardness gage, Model B.

1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

Two other models, A and B-75, are in use, but are not covered in this test method. Model A does not provide numerical values of hardness and Model B-75 covers only a part of the range of interest for aluminum alloys.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Significance and Use

The Webster hardness gage is portable and therefore useful for in situ determination of the hardness of fabricated parts and individual test specimens for production control purposes. It is not as sensitive as Rockwell or Brinell hardness machines; see 10.2.

This test method should be used only as cited in applicable material specifications.

FIG. 1 Webster Hardness Gage, Model B

Keywords

aluminum alloys-indentation hardness; hardness (indentation)-aluminum alloys; hardness tests-Webster; Webster hardness; indentation hardness-Al-alloys, by Webster hardness guage, test; ICS Number Code 77.120.10 (Aluminium and aluminium alloys)

To find similar documents by ASTM Volume:

02.02 (Aluminum and Magnesium Alloys)

To find similar documents by classification:

77.120.10 (Aluminium and aluminium alloys)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.