ASTM-B107 › Historical Revision Information
Standard Specification for Magnesium-Alloy Extruded Bars, Rods, Profiles, Tubes, and Wire
Show Complete Document History
The following bibliographic material is provided to assist you with your purchasing decision:
This specification covers magnesium-alloy extruded bars, rods, profiles, tubes, and wire. The bars, rods, profiles, tubes, or wire shall conform to the chemical requirements specified. Tensile properties such as tensile strength, yield strength, and elongation of magnesium alloys shall be determined. All material shall be of uniform quality, free from injurious surface defects, and shall have a workmanlike finish.
Scope
1.1 This specification covers magnesium-alloy extruded bars, rods, profiles, tubes, and wire of the composition given in .
1.2 The values stated in either inch-pound or SI units are to be regarded separately as standards. The SI units are shown in brackets or in separate tables or columns. The values stated in each system are not exact equivalents; therefore, each system must be used independent of the other. Combining values from the two systems may result in nonconformance with the specification.
1.3 Unless the order specifies the "M" specification designation, the material shall be furnished to the inch-pound units.
Keywords
compositions; dimensional tolerances; extrusions; magnesium; mechanical properties; ICS Number Code 77.150.20 (Magnesium products)
To find similar documents by ASTM Volume:
02.02 (Aluminum and Magnesium Alloys)
To find similar documents by classification:
77.150.20 (Magnesium products)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-B107/B107M-07
Revision Level
2007 EDITION
Status
Superseded
Modification Type
Revision
Publication Date
June 1, 2007
Document Type
Specification
Page Count
19 pages
Committee Number
B07.04