ASTM-A689 › Standard Specification for Carbon and Alloy Steel Bars for Springs

ASTM-A689 - 1997 R18 EDITION - CURRENT
Show Complete Document History

Document Center Inc. is an authorized dealer of ASTM standards.
The following bibliographic material is provided to assist you with your purchasing decision:


This specification covers hot-wrought steel bars for the manufacture of general purpose springs such as coil, torsion, and leaf. The steel shall be melt processed by using open-hearth, basic-oxygen, or electric furnace. The materials shall undergo heat analysis and shall conform to the required chemical compositions and hardenability. The steel specimens shall conform to the required values of rounded corner radii and cross section tolerances for round-edge flat bars.

ORDER

Price:

$61.00        


Want this as a site license?

Scope

1.1 This specification covers hot-wrought steel bars to be used for the manufacture of general-purpose springs such as coil, torsion, and leaf.

1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.3 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Keywords

ICS Number Code 77.140.25 (Spring steels)

To find similar documents by ASTM Volume:

01.05 (Steel--Bars, Forgings, Bearing, Chain, Tool)

To find similar documents by classification:

77.140.25 (Spring steels)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.

 

Customers who bought this document also bought:

ASTM-E18
Standard Test Methods for Rockwell Hardness of Metallic Materials

ASTM-E384
Standard Test Method for Microindentation Hardness of Materials

ASTM-E10
Standard Test Method for Brinell Hardness of Metallic Materials

Document Number

ASTM-A689-97(2018)

Revision Level

1997 R18 EDITION

Status

Current

Modification Type

Reapproval

Publication Date

Sept. 1, 2018

Document Type

Specification

Page Count

4 pages

Committee Number

A01.15