Document Center is acquired by Nimonik

Scope

1.1 This specification covers grades of stainless steel tubing in sizes under ½ down to 0.050 in. (12.7 to 1.27 mm) in outside diameter and wall thicknesses less than 0.065 in. down to 0.005 in. (1.65 to 0.13 mm) for general corrosion-resisting and low- or high-temperature service, as designated in Table 1.

Note 1--The grades of austenitic stainless steel tubing furnished in accordance with this specification have been found suitable for low-temperature service down to -325^oF (-200^oC) where Charpy notched-bar impact values of 15 ft[dot]lbf (20 J), minimum, are required and these grades need not be impact tested.

1.2 Optional supplementary requirements are provided and, when desired, shall be so stated in the order.

1.3 The values stated in inch-pound units are to be regarded as the standard.

Keywords

austenitic stainless steel; seamless tube; small diameter; stainless steel tube; welded steel tube

To find similar documents by ASTM Volume:

01.01 (Steel--Piping, Tubing, Fittings)

To find similar documents by classification:

23.040.10 (Iron and steel pipes Steel pipes and tubes for specific use, see 77.140.75)

23.040.40 (Metal fittings)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.