ASTM-A623 › Standard Specification for Tin Mill Products, General Requirements
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This specification covers a group of common requirements which, unless otherwise specified in the purchase order or in an individual specification, shall apply to tin mill products.
1.2 In case of any conflict in requirements, the requirements of the purchase order, the individual material specification, and this general specification shall prevail in the sequence named.
Note 1—A complete metric companion to Specification A 623 has been developed-Specification A 623M; therefore no metric equivalents are presented in this specification.
1.3 The following safety caveat pertains to through of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
Modul-R; R-bar; ICS Number Code 77.140.50 (Flat steel products and semi-products)
To find similar documents by ASTM Volume:
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Customers who bought this document also bought:
ASTM-A370Standard Test Methods and Definitions for Mechanical Testing of Steel Products
AMS-2759/2
Heat Treatment of Low-Alloy Steel Parts Minimum Tensile Strength 220 ksi (1517 MPa) and Higher
AMS-2759/7
Carburizing and Heat Treatment of Carburizing Grade Steel Parts
Document Number
ASTM-A0623-22
Revision Level
2022 EDITION
Status
Current
Modification Type
Revision
Publication Date
April 1, 2022
Document Type
Specification
Page Count
39 pages
Committee Number
A01.20