ASTM-A617 Standard Specification for Axle-Steel Deformed and Plain Bars for Concrete Reinforcement (Withdrawn 1999)

ASTM-A617 - 1996A EDITION - SUPERSEDED -- See the following: ASTM-A160 ASTM-A305 ASTM-A617/A617M ASTM-A996
Show Complete Document History

Document Center Inc. is an authorized dealer of ASTM standards.
The following bibliographic material is provided to assist you with your purchasing decision:

Standard Specification for Axle-Steel Deformed and Plain Bars for Concrete Reinforcement (Withdrawn 1999)

Scope

1.1 This specification covers deformed and plain axle-steel bars for concrete reinforcement. The standard sizes and dimensions of deformed bars and their number designations shall be those listed in Table 1.

1.1.1 The text of this specification references notes and footnotes which provide explanatory material. These notes and footnotes (excluding those in tables and figures) shall not be considered as requirements of this specification.

1.2 Bars are of two minimum yield levels: namely, 40 000 psi [300 MPa] and 60 000 psi [420 MPa], designated as Grade 40 [300] and Grade 60 [420], respectively.

1.3 Plain rounds, in sizes up to and including 2 in. [50.8 mm] in diameter, in coils or cut lengths, when specified for dowels, spirals and structural ties or supports shall be furnished under this specification in Grade 40 [300] and Grade 60 [420]. For ductility properties (elongation and bending), test provisions of the nearest smaller nominal diameter deformed bar shall apply. Requirements providing for deformations and marking shall not be applicable.

1.4 The weldability of the steel is not a requirement of this specification.

1.5 This specification is applicable for orders in either inch-pound units (as Specification A617) or SI units [as Specification A617M].

1.6 The values stated in either inch-pound units or SI units are to be regarded as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with the specification.

Keywords

Axle steel bars; Concrete; emreinforcement; Deformations (protrusions); Reinforcing steels/concrete; Steel bars; emconcrete reinforcement; bars; emaxle-steel deformed/plain, for concrete reinforcement

To find similar documents by ASTM Volume:

01.04 (Steel--Structural, Reinforcing, Pressure Vessel, Railway)

To find similar documents by classification:

77.140.15 (Steels for reinforcement of concrete)

This document comes with our free Notification Service, good for the life of the document.

This document is available in Paper format.

 

Customers who bought this document also bought:

MIL-STD-202
Test Method Standard for Electronic and Electrical Component Parts

MIL-STD-2073/1
Standard Practice for Military Packaging

FED-STD-209
Airborne Particulate Cleanliness Classes in Cleanrooms and Clean Zones (Cancelled, replaced by ISO-14644 series)

Document Number

ASTM-A617/A617M-96a

Revision Level

1996A EDITION

Status

Superseded

Modification Type

Replaced

Publication Date

May 10, 1996

Document Type

Specification

Page Count

4 pages

Committee Number

A01.05