Document Center is acquired by Nimonik

Scope

1.1 This specification covers deformed steel wire which has been cold-worked by drawing, rolling, or both drawing and rolling, to be used as produced, or in fabricated form, for the reinforcement of concrete in sizes having nominal cross-sectional areas not less than 6.45 mm ² [0.01 in.²].

1.2 Supplement S1 describes high-strength wire, which shall be furnished when specifically ordered. It shall be permissible to furnish high-strength wire in place of regular wire if mutually agreed to by the purchaser and manufacturer.

1.3 The values stated in SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard (The inch-pound units are shown in brackets except in Table 1).

Keywords

concrete reinforcement; deformations (indentations); steel wire; ICS Number Code 77.140.15 (Steels for reinforcement of concrete)

To find similar documents by ASTM Volume:

01.04 (Steel--Structural, Reinforcing, Pressure Vessel, Railway)

To find similar documents by classification:

77.140.15 (Steels for reinforcement of concrete)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.