Document Center is acquired by Nimonik

Scope

1.1 This specification covers a quality of round and shaped plain carbon and alloy steel spring wire, uniform in quality and temper, intended for the manufacture of mechanical springs that can withstand moderate fatigue stresses over some relatively low number of cycles. The quality level is between the commercial quality grades of wire such as Specifications A401, A231, and A229 and the valve spring quality grades such Specifications as A230, A232, A877 and A878. It is similar to the grade TD (referenced in EN 10270-2) intended for medium fatigue levels, such as required for clutch springs. This wire shall be either in the annealed and cold-drawn or oil-tempered condition as specified by purchaser.

1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. Within the text, the inch-pound units are shown in parentheses. The values stated in each system are not exact equivalents; therefore, each system must be used independent of the other.

Keywords

oil-tempered, shaped wire, flat rolled, inclusion content, eddy current, alloy; ICS Number Code 77.140.25 (Spring steels)

To find similar documents by ASTM Volume:

01.03 (Steel--Plate, Sheet, Strip, Wire; Stainless Steel Bar)

To find similar documents by classification:

77.140.25 (Spring steels)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.