ASTM-F577 › Standard Test Method for Particle Size Measurement of Dry Toners (Withdrawn 2017)
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method covers aperture particle size analysis using an electronic sensing zone apparatus provided with a digital pulse processor. Dry inks, toners, and so forth, are covered. Particles as small as 1 μm and as large as 120 μm can be analyzed.
1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Significance and Use
This test is useful in determining particle size characteristics of dry toners used in electrostatic imaging devices such as copiers and laser printers. It is a practiced method for use in quality control of toner particle size.
Keywords
dry toners; particle size; Dry toners; Electronic sensing zone apparatus; Electrostatic copier; Particle analysis--toners; ICS Number Code 19.120 (Particle size analysis. Sieving)
To find similar documents by ASTM Volume:
15.09 (Paper; Business Imaging Products)
To find similar documents by classification:
19.120 (Particle size analysis. Sieving Including test sieves and porosimetry)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-F577-03(2009)
Revision Level
2003 R09 EDITION
Status
Cancelled
Modification Type
Withdrawn
Publication Date
Feb. 1, 2009
Document Type
Test Method
Page Count
7 pages
Committee Number
F05.04