ASTM-F405 › Standard Specification for Corrugated Polyethylene (PE) Pipe and Fittings (Withdrawn 2015)

ASTM-F405 - 2013 EDITION - SUPERSEDED -- See the following: ASTM-F667
Show Complete Document History

Document Center Inc. is an authorized dealer of ASTM standards.
The following bibliographic material is provided to assist you with your purchasing decision:


This specification covers the physical and dimensional requirements and associated test methods for corrugated polyethylene (PE) pipe and fittings intended for underground applications, particularly in soil drainage and septic field leach beds, where soil support is given to the flexible walls. Pipe and fittings shall adhere to physical test requirements such as elongation, brittleness, pipe stiffness, and perforations.

ORDER

Want this as a site license?

Scope

1.1 This specification covers requirements and test methods for materials, marking dimensions, workmanship, elongation, brittleness, pipe stiffness, and perforations for corrugated polyethylene (PE) pipe and fittings in nominal sizes of 3 to 6 in., inclusive.

1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard..

Note 1—Along with sizes 3 to 6 in. covered in this specification, sizes 4 to 24 in. are described in Specification F667.

1.3 The text of this specification references notes and footnotes that provide explanatory material. These notes and footnotes (excluding those in tables and figures) shall not be considered as requirements of the specification.

1.4 The following precautionary caveat pertains only to the test methods portion, Section 8, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Keywords

ICS Number Code 23.040.20 (Plastic pipes); 23.040.45 (Plastic fittings)

To find similar documents by ASTM Volume:

08.04 (Plastic Piping Systems)

To find similar documents by classification:

23.040.20 (Plastics pipes)

23.040.45 (Plastics fittings)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.

 

Customers who bought this document also bought:

ASME-HST-5
Performance Standard for Air Chain Hoists

MIL-C-26482
Connectors, Electrical, (Circular, Miniature, Quick Disconnect, Environment Resisting)

CGA-C7
Guide to Classification and Labeling of Compressed Gases

Document Number

ASTM-F405-13

Revision Level

2013 EDITION

Status

Superseded

Modification Type

Replaced

Publication Date

Aug. 15, 2013

Document Type

Specification

Page Count

5 pages

Committee Number

F17.65