ASTM-F362 › Standard Test Method for Determining the Erasability of Inked Ribbons (Withdrawn 2016)
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method covers the determination of the erasability of inked ribbons.
1.2 Results are expressed in visual ranking order or in comparison to a control.
1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Significance and Use
This test method is used to compare the relative erasability of similar ribbons having approximately the same amount (degree) of ink (inking) transfer capability. It is suitable for compiling rankings for comparative testing against a control ribbon for service evaluation and quality control (research).
Keywords
abrasion; erasability; inked ribbons; typewriter; typewriter ribbons; Erasability; Inked ribbons; ICS Number Code 35.260 (Office machines)
To find similar documents by ASTM Volume:
15.09 (Paper; Business Imaging Products)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-F362/F362M-91(2010)e1
Revision Level
1991 R10(E1) EDITION
Status
Cancelled
Modification Type
Withdrawn
Publication Date
Dec. 1, 2010
Document Type
Test Method
Page Count
2 pages
Committee Number
F05.02