ASTM-F1442 › Standard Practice for Using a Copier or Printer as a Test Instrument for Evaluating Paper Performance (Withdrawn 2015)
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This practice covers a standardized procedure for utilizing a copier or printer as an imaging device when performance properties of paper are to be determined.
1.2 Copiers and printers are limited to those using the indirect electrophotographic process.
1.3 The paper is limited to cut-sized office papers.
1.4 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific precautionary statements are given in Appendix X1.1.
Significance and Use
This practice may be used to satisfy the requirements of Specification D3460 when performance in the intended use in a printer or copier is required.
Describing physical parameters of paper alone is not sufficient to ensure performance in a copier or printer.
Curl, both before and after imaging, may effect copier or printer performance.
The presence of contaminants in the paper that are tacky or thermoplastic, or both, may be transferred to the photoconductor or fuser rolls. They may cause an unwanted image. These are referred to as“ stickies.” Some papers, especially those containing recycled fiber, have exhibited this problem.
Transfer of ream sealing adhesive or ream wrapper laminant to the photoconductor or fuser rolls can cause problems similar to those described in 5.4.
Keywords
copier paper; paper performance; printer paper; stickies; Copy materials/products--electrophotographic; Electrophotographic processing; Image analysis--copy materials; Performance--copy materials; Printers; Stickies; Visual examination--copy materials; ICS Number Code 37.100.10 (Reproduction equipment)
To find similar documents by ASTM Volume:
15.09 (Paper; Business Imaging Products)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-F1442-92(2009)
Revision Level
1992 R09 EDITION
Status
Cancelled
Modification Type
Withdrawn
Publication Date
Nov. 15, 2009
Document Type
Practice
Page Count
4 pages
Committee Number
F05.03