ASTM-D5094 Standard Test Methods for Gross Leakage of Liquids from Containers with Threaded or Lug-Style Closures (Withdrawn 2023)

ASTM-D5094 - 2009 R14 EDITION - CANCELLED
Show Complete Document History

Document Center Inc. is an authorized dealer of ASTM standards.
The following bibliographic material is provided to assist you with your purchasing decision:

Standard Test Methods for Gross Leakage of Liquids from Containers with Threaded or Lug-Style Closures (Withdrawn 2023)

Scope

1.1 These test methods may demonstrate container/closure integrity with threaded or lug-style closures by the determination of gross leaks in rigid and semi-rigid containers (up to 4 L [1.06 g]. Such tests may be used to indicate the ability of a liquid container to survive the distribution environment without leaking. These test methods may not be suitable to determine the leak resistance of containers intended for transport of hazardous materials.

1.2 Test Methods: 

1.2.1 Test Method A, Shipping Container Vibration and Storage Test, covers the ability of a shipping container and its interior packaging to protect the contents from leakage after transportation induced vibration and high-temperature storage.

1.2.2 Test Method B, Shipping Container Vibration and Vacuum Chamber Test, is suitable for individual containers and is usually less severe than Test Method A. The advantage of Test Method B is the shortness of the test.

1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.4  This standard does not purport to address the safety conserns associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Significance and Use

5.1 These test methods are used to indicate the integrity of the container and closure system in the distribution environment.

5.2 These test methods measure the ability of the container and closure system to prevent leakage when stored or transported upright, inverted, or on the side.

5.3 These test methods allow for comparison of container/closure designs of threaded and lug-style closures of similar or different materials, or different manufacturers. These tests are suitable for packaging development, engineering and tooling evaluations.

Keywords

closure leakage; container leakage; leak; leakage; liquid leakage; vacuum ;

To find similar documents by ASTM Volume:

15.10 (Packaging; Flexible Barrier Packaging)

To find similar documents by classification:

55.180.10 (General purpose containers)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.

 

Customers who bought this document also bought:

ASTM-D4169
Standard Practice for Performance Testing of Shipping Containers and Systems

ASTM-F88
Standard Test Method for Seal Strength of Flexible Barrier Materials

ANSI/AAMI-ST79
Comprehensive guide to steam sterilization and sterility assurance in health care facilities (ANSI/AAMI ST79:2017)

Document Number

ASTM-D5094/D5094M-09(2014)

Revision Level

2009 R14 EDITION

Status

Cancelled

Modification Type

Withdrawn

Publication Date

Dec. 1, 2014

Document Type

Test Method

Page Count

3 pages

Committee Number

F02.40