ASTM-D4041 Standard Practice for Determining Spray Patterns of Mechanical Pump Dispensers

ASTM-D4041 - 2015 R17 EDITION - CURRENT
Show Complete Document History

Document Center Inc. is an authorized dealer of ASTM standards.
The following bibliographic material is provided to assist you with your purchasing decision:

Standard Practice for Determining Spray Patterns of Mechanical Pump Dispensers
ORDER

Price:

$61.00        


Want this as a site license?

Scope

1.1 This practice covers the determination of spray patterns from pump dispensers.

1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Significance and Use

4.1 This practice can be used to compare spray patterns of different pump dispensers and of different products.

4.2 Spray patterns from pump dispensers will vary greatly with the design of the actuator and the nature of the liquid. Liquids with differing physical properties will not necessarily yield the same spray pattern when sprayed from the same actuator. Likewise, actuators of different designs will yield spray patterns distinct from each other when the same liquid is used.

Keywords

measurement of spray patterns from pump dispensers; pump dispensers—spray pattern; spray pattern measurement ;; ICS Number Code 55.130 (Aerosol containers)

To find similar documents by ASTM Volume:

15.10 (Packaging; Flexible Barrier Packaging)

To find similar documents by classification:

55.130 (Aerosol containers)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.

Document Number

ASTM-D4041/D4041M-05(2017)

Revision Level

2015 R17 EDITION

Status

Current

Modification Type

Reapproval

Publication Date

Dec. 1, 2017

Document Type

Practice

Page Count

3 pages

Committee Number

F02.30