ASTM-D1435 › Standard Practice for Outdoor Weathering of Plastics
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This practice is intended to cover procedures for the exposure of plastic materials to weather.
Note 1: See Practice G24 for aging under glass.
1.2 This practice is limited to the method by which the material is to be exposed and the general procedure to be followed. It is intended for use with finished articles of commerce as well as with all sizes and shapes of test specimens.
1.3 Means of evaluation of the effects of weathering will depend on the intended use for the test material.
1.4 The values stated in SI units are to be regarded as the standard.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
Note 2: This standard and ISO 877.2-2009, Method A, are technically equivalent.
1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Significance and Use
4.1 Tests conducted in accordance with this practice are used to evaluate the stability of plastic materials when they are exposed outdoors. The relative durability of plastics in outdoor use can be very different depending on the location of the exposure because of differences in ultraviolet (UV) radiation, time of wetness, temperature, pollutants, and other factors. It cannot be assumed, therefore, that results from one exposure in a single location will be useful for determining relative durability in a different location. Exposures in several locations with different climates that represent a broad range of anticipated service conditions are recommended.
4.1.1 Because of year-to-year climatological variations, results from a single exposure test cannot be used to predict the absolute rate at which a material degrades. Several years of repeat exposures are needed to get an average test result for a given location.
4.2 The results of short-term exposure tests can provide an indication of relative outdoor performance, but it is recommended they not be used to predict the absolute long-term performance of a material. The results of tests conducted for less than twelve months will depend on the particular season of the year in which they begin.
Keywords
exposure; natural weathering; outdoor weathering; plastics;
To find similar documents by ASTM Volume:
08.01 (Plastics (I): D256 - D3159)
To find similar documents by classification:
83.080.01 (Plastics in general)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Customers who bought this document also bought:
RTCA-DO-160Environmental Conditions and Test Procedures for Airborne Equipment
ASTM-D1003
Standard Test Method for Haze and Luminous Transmittance of Transparent Plastics
MIL-STD-810
Environmental Engineering Considerations and Laboratory Tests
Document Number
ASTM-D1435-20
Revision Level
2020 EDITION
Status
Current
Modification Type
Revision
Publication Date
Oct. 21, 2020
Document Type
Practice
Page Count
5 pages
Committee Number
D20.50