ASTM-A963 › Standard Specification for Deep Drawing Steel (DDS), Sheet, Carbon, Cold-Rolled (Withdrawn 2000)
Show Complete Document History
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This specification covers cold-rolled carbon deep drawing steel (DDS) sheet, in coils and cut lengths. This material is intended for fabricating identified parts where very severe drawing or forming in excess of the abilities of materials covered by Specification A 620/A 620M may be involved. Some aging may occur with this product.
1.2 The values stated in either inch-pound units or SI (metric) units are to be regarded separately as standard. Within the text the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other.
Keywords
carbon steel sheet; cold rolled steel sheet; deep drawing steel; steel sheet
To find similar documents by ASTM Volume:
01.03 (Steel--Plate, Sheet, Strip, Wire; Stainless Steel Bar)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in Paper format.
Document Number
ASTM-A963/A963M-97
Revision Level
1997 EDITION
Status
Superseded
Modification Type
Replaced
Publication Date
March 10, 1997
Document Type
Specification
Page Count
2 pages
Committee Number
A01.19