ASQ-Z1.4 › Historical Revision Information
Sampling Procedures and Tables for Inspection by Attributes - Paper Format - Reaffirmed in 2013
Sampling Procedures and Tables for Inspection by Attributes - Paper Format - Reaffirmed in 2018
Abstract
ANSI/ASQ Z1.4-2008 Sampling Procedures and Tables for Inspection by Attributes is an acceptance sampling system to be used with switching rules on a continuing stream of lots for Acceptance Quality Limit (AQL) specified. It provides tightened, normal, and reduced plans to be applied for attributes inspection for percent nonconforming or nonconformities per 100 units.
Both ANSI/ASQ Z1.4 “Sampling Procedures and Tables for Inspection by Attributes” and ANSI/ASQ Z1.9 “Sampling Procedures and Tables for Inspection by Variables for Percent Nonconforming” are to be used with a continuous supply. ANSI/ASQ Z1.4 is to be used with go/no-go data (sometimes called attribute data). ANSI/ASQ Z1.9 is to be used with measurements. Also note that Z1.9 assumes a normal distribution.
ANSI/ASQ Z1.4-2008 replaces ANSI/ASQ Z1.4-2003.
Notes
Claudia's Notes:
You may be able to remember back when this document was known as ASQC Z1.4. The Standards Developing Organization that develops this standard changed it's name from the American Society for Quality Control to the American Society for Quality in 1997. When it did so, all it's document numbers changed from ASQC-xxx to ASQ-xxx!
This document comes with our free Notification Service, good for the life of the document.
This document is available in Paper format.
Document Number
ANSI/ASQ Z1.4-2003 (R2013)
Revision Level
2003 R13 EDITION
Status
Superseded
Publication Date
Oct. 1, 2013